Pushpull Meter is a force measuring instrument for both Push and Pull. There is ZERO ADJUST. An additional red pointer retains the maximum reading encountered.

RED POINTER retains the maximum reading encountered. By rotating it anti-clockwise set it to zero again.

Because of gravity the METER when held inclined (or upside down) shows reading different than when held vertically. To nullify gravity effect, turn ZERO ADJUST holding the METER the same way as will be held while measuring.

Spot calibration gives better results. Apply standard force ( the one nearest to the force to be measured), and with the ZERO ADJUST make the instrument read the value of the standard force.

METERS with capacities below 2 kg. may require a light tap to overcome static friction .

To prevent damages to inside parts, hold the pushing/pulling ROD firmly while changing accessories at its ends.

Do no push the PULL END or pull the PUSH END. It has overload capacity of 30%. METER can be clamped on SQUARE BODY.

Warranty of one year (invalid if tampered with).